Spectrometer Version 2 and 3

I have continued working on my spectrometer. I focused on 2 types, one that places the sample on the outside the spectrometer between the light source and the slit. The other where the sample is placed within the housing in a sample holder.

Version 2 Image 1

Here in the first version (image 1) you can see the camera and the diffraction grating are mounted on the right side at a 30 degree angle. Both camera mount and grading are 3D printed but can easily be made by using metal or plastic 'L' brackets.

Image 2

In this image (image 2) you can see how I mount 2 single sided razors to create my slit for the light to go through to the diffraction grating and then to camera. The razors have a very sharp edge and I am able to make very fine slits for the light to pass through. There is a small notch in the razors that the screws go through that allows for adjustment of the blades to increase and decrease the width of the slit.

Image 3 Version 3

In this 3rd image I am still working on this spectrometer. There is a camera holder with a 30 degree angle positioning, next going to the right is going to be a grading holder (the hole has been drilled to hold it in place). From there we go to the slit and then the sample holder. All these I have 3D printed. On the right side of the box you can see the hole drilled out to mount my LED light. I intend to use different light sources that have - white LED, RGB LED for different colours, UV LED, IR LED and different lasers, red and green for now.

Both cases are painted black on the inside. All 3D printed parts were printed in black PLA. I am using the Theremino spectrometer software.

I am also looking at building a nano-drop spectrometer more on that later.