Media Pump

Using a Syringe Filter to Sterilize Media:

Syringe and Filter

I picked up some syringe filters from Amazon figuring I could use a syringe to pass my media or water through the filter. As seen in photo the filter screws on to the top of syringe. This filter membrane has a pore size of .22 micrometers. This should easily sterilize the fluids.

Parts

 

Thinking there must be an easier way to run the media or water through the filter I picked up a 12V DC DIY Peristaltic Liquid Pump from Amazon. As seen in this image as well as the pump I picked up air hose tubing and airline tubing connectors from a pet store. The connectors allows different sized tubing to fit together.

Fitting to hold filter

I had a medical drop administration set I found at a flee market. This has the same type of connection as the syringe tip has, allowing the filter to screw on. As seen in the above image.

Unit put together

In the final image you can see the whole unit put together. I am using a 12 volt wall adapter hooked up to the motor speed controller (previous project) to control the pump motor. The filter holder was made with a 1/4 inch dowel and clothes pin glued together.

I pump the fluids through the system slowly as to hopefully not cause a big mess if it ever backs up. I intend to mount the pump into a weighted box so I don't set it up when I need to use it.