Sunday, June 2, 2013

DremelFuge - centrifuge

Warning - be careful when using or building a centrifuge, they are very dangerous. If at all possible try and buy a professional one.

Here is a centrifuge created by Cathal Garvey called DremelFuge. It can be found here:

http://www.thingiverse.com/thing:1483

It uses standard 1.5ml/2ml Eppendorf/Microcentrifuge tubes. Works with both a drill or Dremel.

DremelFuge

I was trying to get it printed out but I was having trouble with it. So I decided I would try to make my own from parts laying around. It consists of a 3.5 inch PVC plumbing cap and a bolt, nut and washer. As seen below I have it running on a drill press. I did try it on a dremel, it worked, but I would not use it that way unless a closed off compartent is built for it (later project).

Homemade dremelfuge

Working in drill press

1 comment:

Anonymous said...

Would this be possible to accomplish on a 3D printer?